There are several reasons why replace MTP cable copper cable for many applications in the computer room. The most important reason is the prerequisite for a much greater bandwidth for high-definition audio conferencing systems and HDTV. This will require higher speeds to meet the information and optical fiber cable has a much higher bandwidth copper cable.

Another important reason for this trend is that the fiber optic cable connectors (LC, in particular) are smaller than the copper cables and require less actual return on real estate plan servers, switches and routers for the data system. This is the reason that manufacturers turn to LC connectors on some of their servers and switches.

fiber is in many cases where power lines near the data lines run to prevent electromagnetic interference, preferable that the fiber-optic cables are hiding. Where there is air conditioning and fans / or which may be necessary for the computer system and are close to the data cabling with fiber optic cables to prevent interference with the cross-talk data signals.

distance considerations are also important in creating a system of computer data space. With fiber optic cables, we are able, the distances that we can perform high-speed data transmission over copper cable to be extended. If there are older copper cable systems, which must remain in operation, there are media converters that interface with the network of 12 ports of fiber MTP connector fiber mass layoffs and have several ports, RJ 45 on the front side of the interface of copper cables. Small media converters are also available and Ethernet interface, or two ports of copper on the duplex input and converts the signal to one or two fiber optic ports for duplex 10/100/1000 Gigabit-output systems. Using these devices, the existing system to the interface has to be extended further than previously possible.

If you have hundreds of copper cables from the server to the switch, you can actually impede the flow of air under the floor of the computer room. If you are dealing with smaller, thinner fiber, you do not have to put up much of a block to your air flow. When you walk through walls between the rooms must, computer necessary holes are much smaller and easier to shoot. The weight of the cable held by the title on top of the housing is also much less and much less bulky.

The cassette module LC is a compact, high density fiber optic solution to save space and allow equipment cabinet data to travel longer distances. LC cassette module is a module distribution that connected one or two twelve-fiber MTP connector on one side to twelve or 24-fiber connectors such as LC, on the other side. It is sealed in a metal housing that provides good protection fiber. The tape can easily be replaced during a maintenance cycle. The LC connector is half the size of the SC connector, which reduces the space required.

cartridges in a rack or wall mount fiber distribution boxes reside with 3, 6, 9 or 12 cassettes. Each cartridge can handle 12 or 24 fibers. The fiber optic cable pulled are of high density, multi-fiber trunk cable end MTP plug or be made quickly from point A to point B. With a belt or a cable assembly of the transfer, may designer the data center can be the 12 or 24 fiber MTP connector for connecting any simplex or duplex. The fiber has already been tested, engineered flooring, and essentially plug and play. The error can be introduced by pulling individual strands through multiple stages of polishing and termination is not the case. To develop new server, a main cable with MTP connectivity has to be very fast and ready. All tapes or cables should not be installed forward with needed investment. MTP Fiber optic cables are 24, 36, 48, 72 or 144 fibers. The network can be used as servers and switches can be increased.


Fiber optic cable