More than once, the employees who work in certain industries to work on the floor. This usually occurs on construction sites. Therefore, at the rate, is a security risk and is considered the second most common cause of death in the workplace. OSHA, U.S. Occupational Safety and Health Administration has established certain rules and regulations to reduce risks to workers. Protection against falls is one of these regulations and any employer must meet in order to obtain a safe working environment.

In section 1926.501 of the OSHA requirements, protective systems against falling by all employers provided. Those who are more than six meters, about 1.8 meters above a lower level of the work. There are three different types of protection systems against falling accepted by OSHA: railings, harnesses and safety nets. However, not to create situations that demand the use of other systems />
. This must be within 3 inches or 8 inches are appropriate. They should be about 42 inches high with an opening no wider than 19 inches. Guardrails must be strong enough to withstand a force of about £ 200, without falling. Another requirement for a railing is made from the material. It was not something that hurt and tear can hurt people or their clothes. The center of the rails and the top should not those of a material that is less than a quarter of an inch are made. If the material is thin, it can tear an employee under

* Harness. These systems are basically covered the personal. A seat belt, an anchor and lifeline are the primary equipment needed. These systems prevent a worker falling more than six meters. You need twice as strong as the impact energy generated by the staff at this distance. The dishes must be pre-tested to withstand a load of about £ 3600th In addition, it should not be tested each time before they tapped. Cables and harnesses shall be made of synthetic fibers because they are strong compared to other options

* safety nets. The safety net is a different kind of devices that are used to eliminate security risks. These networks need to be near the area, placed in the employee. This means that more than 30 feet must be placed under. Also, the network must be large enough to catch an employee as part of a building. The monitoring of these networks must be performed every six months. To test a network, a big bag to deposit more than £ 400 over the highest point, where employees work.


Protection against falls